Chainsaw mill with Stihl and Logosol
Stihl chainsaw on a portable sawmill from Logosol cutting boards from a log, just like an Alaskan mill. The adventage is that you not only get rough edged boards, but you can also get edged boards or squared cants? Too good to be true? Visit Logosol online to find out,
575XP Chain Saw
575Xp chain Saw Husqvarna, 24inch bar 3/8 skip tooh .050 guage Chain. uses 7/32 file size. 5.7hp 73.5 cc .
Chain Saw Used to Extract an Elephants Tusk
News article brought to you by Stihl and Husqvarna Chain Saws
A chain saw, concrete drills and hand saws were used at the Oregon Zoo to remove the infected tusk of Tusko the elephant. Removing the tusk proved to be a difficult job that took twenty people many hours to accomplish. The rock hard ivory was [...]
Stihl 039 Chainsaw Start and Run
This is video 1 of 6 from the Stihl start and run videos.
stihl ms270 and ms460 chainsaw reveiw
here is a review of 2 of 3 of my saws
Stihl 088 hotsaw chainsaw race
Stihl 088 cylinder mods by Ken Dunn, with pipe
Ported Husqvarna NE 346XP Chainsaw
Ported Husqvarna NE 346XP Chainsaw.
Times are 7.10, 7.30, 7.40, 7.40.
Chain Saw Sharpening Guide
Article brought to you by Stihl and Husqvarna Chain Saws
When to Sharpen
How will you know when the chain needs sharpening? Two things will tell you. Firstly the chain will start to need extra effort to push it through the wood. A sharp chain will cut to the depth of the teeth easily with very little [...]
Chain Saw Maintenance - Turning the Guide Bar
Article brought to you by Stihl and Husqvarna Chain Saws
After about 10 hours of use the bar should be removed and turned to allow for even wear. Check that there is not excessive wear on the bar and replace if necessary. Turn the bar following the instructions below.
Loosen and remove the retaining nuts on the [...]